Custom Billet Shift Knob for Toyota Tacoma (2-1/4" diameter). ***Utilizes factory boot.***

Excellent, you fellas sure made page 69 one to remember.

@Wtsmith
Those stainless knobs really are heavy. Protip, mind your right knee when going over train tracks, haha.

 

That's a Delrin knob, V1 AT (w/ aluminum core).

 

Alright, alright, alright.. The wifey headed out to her sisters so I had enough time to install my new knob! I’m planning on going to hobby lobby soon to get some liquid paint so I can fill the engraving.

 

What configuration is this? It is exactly what I want just with different engravings.

 

Sorry sir late to the posting,are you making these for the 2nd gens also?

 

Honestly, @7r41lbr34k3r will be able to tell you exactly what I got. I went back and forth on a couple things and lost track. All I know is I went with aluminum, knurled delrin around the aluminum, and delrin boot collar. BTW, Install was super easy. Took me a half hour to install not knowing wtf I was doing.

 

Yep, V2 is what you want for 2nd Gen. If for automatic I may need a few shaft dimensions as I haven't had any to make for that yet. MT is proven though.

Yup, V2 AT with those features mentioned.

 

I also have this one. There are tons out there, but these two were my favorite.

 

Yes it is a automatic trans. V2 knob would that be the aluminum knob with knurled delrin center and collar?
is this a V2. Any specs or measurements needed will be happy to supply.

 

Yup, and the collar would be altered to give a tapered transition to the exposed shaft (unless you added a boot to yours).

I drop the order form tomorrow at noon Eastern time. If you are in the next group I'll send you a simple blueprint of the dimensions I need.

 

yes will be using a boot.

 

Perfect. No worries then, it will work as is with no modification .

 

great thanks

 

will the RedlineGoods boot work with your collar?

 

Should work for any boot really unless it is super short. Even if the collar doesn't fit through the small hole on the end you just need to invert it until the opening is big enough. Then position optimally, zip tie it from the inside. This is exactly how the 3rd gens come from the factory.

 

Perfect thanks

 

Here is the link to order form, as promised.

https://goo.gl/forms/zxG91FGgJkd0nxeW2

If the link fails it probably means that I have reached maximum capacity and closed it. It will be closed immediately after 10 deposits have been received. Said deposits are fully refundable until I begin machining, so some of the spots may open up again rather soon. Plenty of notice will be given before I open the form link again if that is the case.

There is a chance that more than 10 orders will make it through before I close down ... naturally I will try to accomodate everyone to the best of my ability.

There may also be room for more than 10 if custom engraving/feature demand is very low. Either way, I will communicate in here as things play out.

 

AWSOME -Just ordered.