Ontario BS Thread

I'm just about to put my all pro axle shims on. Don't tell me that lol

 

Lol it's not that their products are bad . Just terrible customer service and they take forever to deliver. But ignore customers who try to contact them when they don't meet the quoted timeline.

There's been a few threads about them

 

Bingemans? Send me a message next time!!

 

I got an emergency call from Mike at work but missed it. He needed help (pm your FB name and I'll add you to the KW group)

 

I installed the 6112/5160 setup with med Dakars over Xmas break. I put em at the 5th top notch with a headstrong 1/4” spacer for tacolean and although I didn’t do a proper before/after measurement I think got around 3” lift on my ACLB. If you are adding a lot of weight on the front just go top notch.

I don’t have a lot of miles on them yet but definitely stiffer than stock.

 

Is that up in the air? That CV angle is wild

 

ya that was the truck up on blocks off the ground over a pit to do everything at once... 6112/5160s/UCAs/dakars/ubolts/ecgs bushing/carrier bearing spacer/refit airbags/etc. my mechanic was in bed with kidney problems so i did it myself in his shop so at least i had the tools.

was a grueling couple days but mostly went well except i f-ed up the ABS wheel sensor and harness on the driver side. a week or two later i replaced the sensor and pulled the harness. i cut it apart and fixed the harness and seems all good. my LCA bolts are seized too but i think my alignment specs are good enough til i wear out my current tires and move to 33s.

 

Are those stock uca?

 

Holy Moses...

 

Love that guys rig
And he uses it

 

I like the way he did the back end with the utility boxes and high mount “bed”

 

They are aftermarket SPC ones.

 

I'm not usually a picture who're...I think this is a nice combination tho

 

Washed the TuRD cause it was nice out today



Also spent some time under it. Confirmed what I already knew, I took the diff breather off of the housing and it’s rusted right shut inside. My new fittings for the breather extension should be coming this week.

Also confirmed that the nuts on my A/FR sensor are in fact welded the f on with rust so I’ll probably need a new catalytic converter to be able to replace that...

And it goes in next week to get the axle seals done as well as the cam bolts and lca bushings replaced. Busy busy.

 

Looks good

 

Off-road wheels on sport!

 

Sport hood on Off Road lol

 

Wanna trade?

 

I thought you were a newp skewp guy?