1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Issue with tightening mounting screws on Cali Raised Pods

Discussion in 'Lighting' started by chase0fspades, Mar 20, 2019.

  1. Mar 20, 2019 at 9:34 AM
    #1
    chase0fspades

    chase0fspades [OP] _TEALTACO

    Joined:
    Jul 16, 2018
    Member:
    #259581
    Messages:
    41
    Gender:
    Male
    Vehicle:
    07 TRD Off-Road Taco
    Suspension: -OME BP-51 Suspension -Dakar HD Leaf Springs Wheels and Tires: -16x8” +0mm Koenig Countersteer Type X -285/75r16 BFG KM3’s Lighting: -Caliraised 40” Roof Bar -Caliraised 20” Bumper Bar -Caliraised Side Projecting Ditch Lights -Caliraised Fog Lights -Caliraised Campsite Pods Electronics: -BANTAM sPod Controller -Wireless Fridge Monitor -CB Radio -Dual Odyssey 35-PC1400T Batteries -Battery Monitor -Blue Sea Battery Isolator/Switch Armor: -Pelfreybilt Hybrid Front Bumper -4xInnovations Rear High Clearance Bumper w/Swing Out Tire Carrier and Table -4xInnovations Rocksliders w/Kickout and Filler Plates -RCI aluminum skid plates - Front, Transmission, Transfer-Case, Fuel Tank. Off-road/Recovery: -Smittybilt X20 10k Winch -ARB Twin Compressor hidden in bedside -Maxtrax Recovery Boards -Rotopax Fuel/Water Storage -Smittybilt Hi-lift Jack Storage: -Prinsu Design Studios Cabrac Roof Rack -KB Voodoo 10” Modular Bed Rack Camp: -Smittybilt Overlander Roof Top Tent -ARB Elements Fridge -Fridge Slider Other: -Full Wrap in 3M Atomic Teal -Spyder Auto DRL headlights -Spyder LED Tail Lights
    Hey guys and gals, so my lights came in and I tried to get to work mounting them. It looks like Cali Raised tried to make a slot to put the nut into so you can tighten it, but they send you nuts that are too small.

    I hate when the nuts are too small.

    I can push a flat head down in there to tighten them, but it means if I want to adjust the position of the light, I have to remove the entire assembly each time. Really annoying.

    Has anyone found a solution?
     

Products Discussed in

To Top