Cabin blower fan, resistor, and wiring problem

Blower fan went out last year and replaced just the blower. Worked well for about a year and the fan started going out again. I found some forum posts and youtube videos that suggested replacing the resistor and wire harness that connects to it. Checked out the harness to the old resistor, and its a little burnt, but not horrible. I have those parts ready to install.

While I was poking around I realized that the connector that goes directly into the blower is burnt out as well. I think I have found the part number for the "male" side of the connector,



but I cant seem to find the part for the "female" connector that goes into the blower.




I am hoping that I can just replace the resistor, harness and these two connectors. Looking for any suggestions on what parts to get, or for the repair.

Thanks.

 

Welcome to TW

 

Welcome to TW!!

 

Post 26 on this page may help. If not, @Jimmyh seems to know what he's talking about, perhaps he'll join in and help.

https://www.tacomaworld.com/threads/diy-ac-or-heater-only-blowing-on-high-heres-a-fix.541843/page-2

 

Welcome!

 

Welcome!