Need help. Morimoto D2S 5.0 issue

So I’m currently installing D2S 5.0 on my truck. I’m buttoning everything up but I seem to be having some intermentant issues with my lights. When I hook them up they work. Flash the high beams multiple times and if works. But if I cut my lights off and back on they don’t work. I flash the high beams and you can hear the shield working but no lights. If I let them sit for 10 seconds then they will work again. Is this normal? Am I doing something wrong? I’m new to this and mildly panicking. Retrofit source is closed today so I’m leaning on you guys. I apologize if this has been covered before somewhere. Thanks for any help you can provide.

Update: thought I had it fixed. Apparently not. It is doing the same thing. When I pull the ignitor and rotate it, it will work for a few minutes then go back out.

 

Now I’m having issues with the high beams not wanting to work. And when I cut the lights off the passenger side cuts off about 1 second later than the driver. Also, the passenger side is brighter than the drivers side. Pics for reference

 

Try switching bulbs and see if it carries to the drivers side. Could be an unaligned bulb. The passenger side is always going to be a little brighter just because of the overlay but that hot spot is a little low and off center on the passenger side. The driver side doesn't even have a hot spot so that bulb isn't sitting right either.