1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Can LCA bolts cause problems in lift reduction?

Discussion in 'Suspension' started by JARStacoma, Apr 20, 2019.

  1. Apr 20, 2019 at 3:49 PM
    #1
    JARStacoma

    JARStacoma [OP] Well-Known Member

    Joined:
    May 8, 2017
    Member:
    #218524
    Messages:
    652
    Gender:
    Male
    Alaska
    Vehicle:
    17' inferno TRD OR MT
    So this could be a stupid question. I installed my lift with coils last night. After install I had a measurement of 38” ground to fender and was hoping they would settle 1/2 inch. Drove 8 miles home. Woke up and still had a bit of bro lean. Drove mile down the road and parked on level pullout. Measured 36.5 ground pto fender. I’m going crazy trying to figure this out. Before retorquing cam bolts I put jack under LCA and compressed coils all the way to provide load and torqued to 135 lbs.
     

Products Discussed in

To Top