Need help with Bilstein-6112 Setup

I ordered the 2nd Gen Kit 6112 setup for use with my 3rd gen Tacoma. Need recommendations on setting the clips. I would like to hold off on UCA for now. I don't need to max it out, I would like a better ride and to be able to add a larger size tire on the truck. The other question is do I set them the same and use a 1/4 lean spacer? or do I just do the drivers higher then the passengers. The end game is I want a completely level truck. Once the front is set, I will configure the rear to match the front height.

 

What size tire are you looking at? e.g. 265/75 16's won't require any lift...

I'd skip the spacer and set the driver's side 1-setting higher than the pass. side.

 

I am running 265/65/17 right now, I wasn't looking to go beyond 275/70/17 Falken WildPeak AT3's. As I mentioned I don't want to mess with UCA's. The issue I have is the the supplied chart is setup for 2nd gen, its my understanding its higher on the 3rd gen. I was thinking about setting the D side to 4 and P side to 3 in hopes to get 2 inch lift post settling. See Chart below