What Have You Done To Your 3rd Gen Today?

Rather have water spots than love bugs

 

Swapped out my amber grille lights from Runnin4Tacos abs replaced them with their white lights.
Before:


After:


I also added a RotopaX 2G to my rack and swapped my black flag to a red one.

 

Saw these a while back. Not overlays but could be replacements. The A and 6 are not filled in and are less expensive. Not sure of the quality but thought you may want to take a look at them. Good luck on your decision.
https://www.ebay.com/sch/i.html?_from=R40&_trksid=m570.l1313&_nkw=black+tacoma+badges&_sacat=0

 

I went with these from Amazon I really like them

https://www.amazon.com/gp/product/B07K3MRQL4/ref=ppx_od_dt_b_asin_title_s00?ie=UTF8&psc=1

 

Very nice.

 

Is this a front and back?

 

Thanks. I appreciate that. One step at a time.

 

It's for installing a front camera and using the stock rear camera. Plugs in to the head unit and you control the cameras using the steering wheel controls.

 

Pulled my stripes off... was a little too much in my opinion.

 

I’m gonna wear them a while and see. I like em but don’t love em.

 

Ain't that the damn truth! They pop up in clouds around here. Pretty much rinsing the truck off every day for the past week or so.

 

You must be on the gulf coast. They finally finished up in South Louisiana. Time for the first wax job.
We bought the Tacoma and a Honda Pilot two days later. Seems like we have cleaned them daily since e we got them.

 

American flag shouldn’t be below that badge or anything else. Just a heads-up.

 

@Steemax

The Hideaway was really easy. I used these Metra harnesses:

$11 Metra 71-1761 87 - 94 Toyota Vehicle Harness

71-1761 &

$5 Metra 70-1761 Radio Wiring Harness For Toyota 87-Up Power 4 Speaker

70-1761. They're connected together, matching the colored wires on each half. One end of the new harness plugs into the factory harness and the other into the head unit.

I spliced the Hideaway's input wires and remote wire into the newly created Metra harness. The input wires are connected to the grey and white front door speaker wires, and the remote wire to the blue/white amp turn-on wire. The remote wire for the sub is short, so it had to be extended.

The power wire for the sub is routed through the large firewall grommet just to the side of the brake booster. I poked a small hole in it with a sharp pick, and pulled the power wire through by attaching it to some floral wire that I fished through the hole. The ground wire for the sub is attached to one of the seat mounting bolts.

I ran the input and remote wires from the sub under the console and behind the dash. The power wire runs through the existing cutout in the carpet, under it to the door sill trim, and behind the kick panel to the firewall.

This thread is a great reference: https://www.tacomaworld.com/threads...-premium-upgrade-kicker-key-180-4-amp.541375/

And the Hideaway is indeed under the driver seat.

 

The panel is mounted inside the cubby compartment. I don't expect to get much water in there. There are 3 drain holes in the back even is some did splash inside.

 

I'm the same way. I like them, not sure if I love them.

 

Agree

 

Thanks , getting there little by little hehe

 

Very Nice!!! Did you get the OME springs? I'm doing the same soon.

 

That's good that you upgraded the leafs in the rear.. The stock are terrible.