Help. Cyl 2 not firing

@DrZ thanks I’ll give that a look tomorrow and give an update

 

Alright there was no ground from the negative terminal to my body near the battery so I added one

 

I now have power inside my cab. I’m gonna put everything back together and give it a go

 

Yes, nice find. Sounds like you're on your way

 

Anddddd it’s running on three cylinders still. I had power but not running good. Could this be a fuel pressure problem? Any ideas. New distributor cap, plugs, wires, injectors are good.

 

Also it now will run for a couple seconds and then shit itself off, not really a stall but literally shuts it self off. But I can crank it over almost right after it dies and it will start back up for a couple more seconds.

 

If there isn't any MIL codes thrown or pending than I guess I'd start with fuel system stuff since it doesn't necessarily relate to an MIL code. No MIL right? You already scanned it for pending as well?

 

You have EVERYTHING installed? No extra pieces?

 

I believe everything is installed yes, and there is no engine check light. What other fuel systems should I check I’ve gone through injectors

 

Any more ideas?

 

Did you check the compression on cylinder #2 yet?

 

Sounds like that’s the next step