Good morning tacoma world

Hi guys,I'm new here and was wondering if anyone knows how to run KC lights from top of roll bar in the bed to switch inside the cab..not sure where/how to drill

 

Try searching around on here for a DIY of wiring up a light bar...I would think it would be quite similar. Hopefully requires very little drilling, as it's going to connect in the vicinity of where other wires already exist.

 

There is a grommet under the rear seat and then you can fish under the carpet to the center console and up.

Or there is a grommet behind the drivers left foot in firewall.

 

Few people have drilled a hole big enough for the wires and then siliconed it. Keep the hole under the rack that holds the light to hide it