Tacos in St. Louis area

You have to go easy on me my guy, can't use these emojis like that

 

Hahahahaha

 

All part of my (not so short) list.

 

My list is getting shorter the longer I own the truck lol
Deciding not to do as much for now

Edit. By not much I mean front and rear bumper. Lol

 

My Tacoma list is getting shorter finally. I need to tie a few more things into my switch pro and reroute some power, install my front camera and get my goose gear seat delete in. After that, all I’ve got left is my HAM radio (whenever I decide what I’m putting in) and my decision on if i go fox 2.5 or bp-51s

 

Lies

 

Are ya now ill wait for next week and see

 

If I were to weld up some sliders at the end of the summer in some downtime (modeling them after this)
https://www.tacomaworld.com/threads...nkensteins-helper.390488/page-9#post-13568830
1/8" wall or 3/16 wall and opinions on doing a square outside tube instead of round

Also how far back do full skid plate rows go?
If I were to make a front to cover the radiator and trans then a rear to go back to the end of the gearbox and put in a support from the frame would I be pretty well protected?

I got a couple of free weeks at the end of the summer and need something to do

 

Save you some time if you like. Got a set of 4X sliders around here somewhere. Weld on type, just need mounting legs.

 

Sweet. What gen are they made for? I might have to modify the length a bit. And do you know if they are the DOM steel or normal.

 

@Tacomania

 

Can get you the length in a bit. HREW with kick out

 

66” with the kick out. No worries for your DCSB 1st Gen. Let me know if you want em, can bring em to mod day.

 

my list seems to be getting longer as of late, now i know why ... thanks to conservation of energy principle

 

is there a suitable substitute for goo gone,
don't want to get a whole bottle just to remove some adhesives left behind on my engine compartment rails from the bodyshop's fckup
perhaps can mix up a homemade small potion of something




...would like to remove this adhesive left behind below before I get a retrofitted stripping, this has been an endless cycle of suckSuck for 5 months now

 

WD40 and a microfiber towel should get you squared away

 

i do have some WD40, will give that a try thanks

 

There is a way to get rid of that nastiness...

 

What I’m gathering from this thread is I need to keep my truck far away from @Tacomania