FS: fridge slide diy project

I started making a fridge slide, but got discouraged 90% away from completion.

I used 2" angle aluminum and 2" flat bar riveted to make what you see. It would need 2 holes to be drilled for mounting, and 2 1" D-rings attached (included). Also including 1 extra piece of 2" flat bar. It should fit Dometic CFX50 and 65. I have a 50, and made it to fit that. I can also provide dimensions if needed.

The slides can hold 100lbs, are soft close ball bearing, and extend 24"

Just looking to get back what I have in materials + shipping. $100 shipped

 

Good deal! What discouraged you?

 

Well an actual slide popped up that i got instead, and im just not sure of my "home engineering". Im just doubting myself.

 

Ah, I get it. I go through that on every project it seems. I built mine as well, learned along the way and now I want to rebuild it haha.

 

Maybe mine is a good starting place for yours?

 

Haha, my fridge is a little too big I think.

 

Hey David, what else is needed to complete this thing?

 

It needs 2 holes drilled into the lower angle, for mounting. And if you wanted to add a lock, you would need to figure that part out.

As is, it slides, but one side needs to be drilled to secure to a mounting location.

 

Bump

 

New low price!

 

Bump

 

Pending

 

SOLD!