Norcal Spotted and BS Thread

What part is bad?

 

What a read

 

They are calling it the 'Right Front Wheel Speed Sensor'. Part number 89542-04020

 

They're not too hard to rebuild, just a little messy and having access to a parts cleaner really helps. I haven't rebuilt 2nd gen tacoma axles but I've rebuilt a handful of 3rd gen T4R axles and some volvo axles. Procedure is about the same for all of them.

 

Yeah, it seems I severed the left side a while back, probably due to what you describe; too tight on the zip tie. I haven't crawled under there yet, but suspect this is the case again. And after the Rubicon, very likely the droop got me.

Thanks.

 

Ya I'm very happy with them. I did the high angle boots on the inner and some cheaper on the outer. Shitty part was the cost of shipping back the cores but that was partially my fault because I used UPS.

Oh and dont forget your new seals and ecgs bushing while your in there

 

Nice. They look good. What did the run you for both??

 

Con: "Bed panels slide instead of lifting up on struts."

Maybe the fact that the author had to reach to find two cons (one being really petty imo) is a testament to the design.

 

A vegan and a CrossFitter walk into a bar. How do I know? They told me.

 

Appears the new neighbor moving in just across the street from me has a nice looking GX470, with a Tepui awning on a Prinsu rack, and dark bronze SCS F-5s, just like mine.

 

Cant remember off hand but I believe that the prices are on his website. They are obviously going to be more expensive than a diy rebuild.

 

Knock Knock

Spoiler: Who's there?

A broken pencil

Spoiler: A broken pencil who?

...never mind, there's no point.

 

So plb 40 for a fridge or what?

 

If only I could erase that last minute.

 

get to dig around the truck and figure out whats up with my steering (at least that what i think is knocking around) when i turn i can hear and feel a knock by the peddles. hoping its just something loose on the steering shaft

 

Steering coupler. Check TSB’s. I’ve had the dealership replace mine twice.

 

From the unfunny pic thread* my favorite for the day.

 

A termite walks into a bar and says, “is the bar tender here?”

 

Has anyone replaced the gasket material on their truck fridge before? I think the ones on mine are old and don't seal very well anymore.