3rd Gen Magnetic Gray Thread

Bought it 2 weeks ago and I'm loving it. This is my first truck.

 

Joined the club 3 weeks ago. 2019 MGM SR 4x4.


MODs so far are:
-Kings 2.5 extended
-SPC UCA
-SCS F5
-285/75/16 KO2's
-Pro Grill w/Raptor Lights
-Baja Designs Fogs
-Clazzio Covers
-Bakflip MX4
-Switchpro
-Cutoms mirrors w/ditch light and Meso puddles (needs install)
-TRD Pro hood and Skid plate (needs install)
More to come...

 

255/80-16 on gray Ray10s —> 275/70-17 on Brushed Copper Ray10s tomorrow. So stoked!

 

Your camber looks WAY off. Was this photo taken post lift, pre alignment?

 

That looks insanely good. I've been debating getting some Goat Armor and this may have tipped the scale.

 

You are correct. Good eye!

 

I want some meatier tires and a lift so bad but my wallet says no

 

Do it!!!

 

First picture included post after lurking all the nooks and crannies of this forum since I got the truck in May. Finally happy with where its at. I still have to remove the beard and install the fender flares (I got some 2nd hand but they are OEM paint matched to SSM and not MGM like the facebook marketplace stated but still a steal at 150$ compared to the $600 toyota wants)

Any thoughts on matte black paint vs matte vinyl vs a Rhino liner coating for the flares? my thoughts were to do the easily reversible first (matte vinyl) and can go with more permanent solutions if I dont like the look or ability to hold up to the elements I get from the vinyl but open to hearing opinions.

Mod lists so far

• 18% tint on front 35% on rear
• Cheap tyger running boards from Amazon
• Black Tacoma Door badges
• Black Tacoma lettering for tailgate
• TRD Pro replica grille with LED lights
• LED High and Low Beams
• Clazzio PVC seat covers
• RAY10 16x8 in Gunmetal
• Falken Wildpeak AT 265/75/16 tires
• Removed the hideous pinstripe that came on the truck

 

Are those the jet black SCS wheels? Can’t decide between black or gunmetal.

 

Are the wind/sun guards weather tech?

 

Worked for a detail shop in high school for the dealer. We would spray down engine bay with degreaser mixed 50/50 the pressure wash lightly. Followed by a light spray down of armor all all over bay.

Close the hood and wash the outside. Looks brand new when done and helps protect hoses and plastic.

 

OME Coil overs and total chaos UCA’s along with OME shocks and deaver leaf springs. Was able to throw on the new tires too. (New to me $700 for the rims and tires) I think it looks awesome! Also replaced my 300 industries grill (1st rusted out so they sent free replacement as they had tested out a new powder coater that didn’t work out well).

 

No they’re AVS brand

 

Keeping it simple for now. Steelies and 265/75/16.

Pic taken in Reno a few weekends ago.

 

Just cheap degreaser wipes from Walmart for the dirtiest parts and waterless wash spray and old microfibers for the rest. I cleaned mine after 2 years and this was the result after relatively minimal work.

 

Just debadge man! Looks so clean on mine I love it. Side benefit is it's easier to clean without badges in the way too.

 

I did end up de-badging the other day.