Just installed wingjet taillights and no blinkers

aloha guys. I just ran into a slight problem while installing my wingjet tail lights. I followed all the instructions to a T and wired everything correctly to prevent any relays shorting or blowing any fuses. Now the lights work but my blinkers don’t. I swapped out my front blinkers to LED (I have an sr5 2019) so no led running lights for me and now my blinkers don’t work at all. I tried the hazard lights and they work perfectly. I had the front leds running for a few months now and only problem I had was a slight hyper flash. Now I’m getting no lights would this need a restrictor? Please help as I’m baffled on where’s to begin.

 

You may need resistors

 

I think you have too much resistance, there was another thread like this not too long ago and the guy had too much resistance which made the blinkers not work

 

Too much resistance? So do I add resistors? It went from having hyper flash with just my front turn signal leds then I installed my rear led tail lights and now no blinkers at all.

 

Take the resistors off of the front blinkers. If there are no resistors on them then the taillights might be defective