What have you done to your Tacoma today? 1st Gen Edition

Have you driven the road that goes to the south side of little hole? Need to go back there fishing and wanted to check that out.

 

I’m assuming this one?
I have, it’s not bad

 

Gotcha. Didn't really read the post the past couple days. Have you tried other ones in that port? I assume the parts stores are still hooking to the same port.

 

Unless it is twisted or cross threaded I have never heard of or even thought of replacing lug nuts as a wear item.

 

Well... One of the good things about camping in 25+freezing rain+snow with your wife is it makes it much easier to get her to approve purchases of new camping gear



Also stopped by Home Depot and bought a hose and some fittings for the air compressor project I'm working on.
80 Bucks for an ARB compressor... I couldn't pass it up.


And ordered a pressure switch, and dash switch.

Just need to get an inline fuse and some wire and I should be able to get it mounted.

And also ordered some deflators

 

Just tried a co-workers bluetooth unit and it worked. Guess my cheapo unit doesn't like my Taco. I replaced my plugs/wires when I did the VC gaskets a few months back, so those should be good. I'm suspecting it's coil related, so I'll swap them around tonight to see if the code follows the coil.

 

is that piece of wiring harness by the oil fill cap (rectangular shaped) loose at all?

 

This?

 

Check your fuse for the actual obd

Edit: nevermind read the last post

 

So let me see if I understand this correctly. The truck you own has to live outside while the car you lease gets pampered inside...

 

Please send a PM when you have these ready for sale. Thx.

 

120 ft/lbs? The torque spec guide for our trucks has it listed at 83 ft/lbs

That always seemed a bit low to me but I've never had an issues with them at that torque.

 

I was joking after reading question "How often to replace lug nuts"

 

Yes 120#, cause then you’ll get to replace the studs too, double win.

 

Sorry, did not receive this tag alert. And you're not even on my ignore list either.

The one I used is

$21 90311-41012 Toyota Oil Seal - 90311-41012

90311-41012 as Mike mentioned. And the stake nut is 90179-22016 but don't buy one. I have an extrea one you can have if you want it.

 

Took a picture of it. Man, impulse red looks like a different color everytime I see it.

 

I made it off your ignore list? Oh man, my day is looking up now .

Thanks for the note about the stake nut, I'll likely take you up on that. Good to have the part number for the future though.

 

yes, thank you

 

From 2 miles out, through a cinder block wall???

Ya, no

 

7mm Rem Mag is the most powerful (commonly used) hunting cartridge used for hunting in North America (close to the same ballistics as 300 Win Mag)

7mm Rem Mag bullet drop at 1000 yards is 236 inches (19.5 feet)... 2 miles is 3520 yards
At only 1000 yards (I use the word "only" loosely... in comparison to 2 miles) the 7mm Rem mag has lost 2/3s of it's energy and over half it's velocity.

There is no way a bullet shot from a hunter's gun went through a cinder block wall at 2 miles. That was a made up story you heard.