Finally got her done

Haven’t had much time for pics but here’s a few to start with.

 

Nice

 

I really dig those wheels...
need info on setup

 

2” front lift 1/2 in the back 16x8 american racing Falken MT 265/75/16 no spacers

 

Sitting pretty.
Looking clean. Nice work

 

De-badged Off-Road with Hood Swap? Did you paint or wrap the hood scoop?

 

debadged sport wrapped flares and scoop and bumper valance

 

Ok. The other way around. I also have a cement Sport and I'm thinking about adding some black accents. I picked the Sport over the OR because I didn't want a Chrome black bumper. I also try to avoid the black flares since they tend to get faded easily. Plus, I like the look of the hood scoop. I may go the same route you did to throw some black accenting in there. And the best thing is that wrap is easily replaceable when it starts fading. How much did you pay for getting the flares/valance/scoop done if you don't mind me asking?

 

Very nice set up! What is the offset on those wheels (great choice btw)?

 

they are a big fat 0 offset

 

OP, you sir did a good job

 

and 4.5 backspacing?

 

my friend owns a vinyl shop so it wasn’t bad. i removed the pieces and took them in. i can’t say what you’d be charged but the outcome is worth it. should be significantly less if you do the hard work.

 

yep

 

Interesting... I have 16x8 wheels with the same offset and backspacing and they seem to come out just a tad bit more...

Love the look. What does your lift consist of?

 

just a 2” spacer in the front and the Toytec 1/2 spacers in the back. alignment came out great and the ride is pretty comparable to stock. i’m sure my balls will be busted for the spacers but i really don’t give a crap. the thing rarely sees dirt so it works for me.

 

Toytec makes 1/2” “spacer” more like a shim but works well for 1/2” lift. slammed some new u bolts on too while i had it apart. they do require replacing the center pin but it was pretty easy just make sure you clamp the spring packs together before you remove the factory pin. i made the mistake of not and i had to aline all the springs. it wasn’t to bad.