Toytec Front Top Spacer Sitting High

Morning everyone. I recently installed the Toytec Top 1 Front Spacer Kit on my 2019 Tacoma DCLB. It has been about a week since installation and the front end is still sitting almost 1 inch about the back. This is based on measuring from hub center to the fender flare. I am wondering if anyone has encountered this problem or has any insight into what might be causing it. My understanding is that the original rake is about 1 inch, so these spacers (advertised to lift the front end 1/2 to 3/4 of an inch) should only make it level or even a little less. Any advise or help is appreciated.

 

Post a couple pics of your install.

There isn’t a general rule for what the different in front and rear height is, the only way to know what your truck needs to leveled is to get a tape measure, compare front to rear heights and find the difference.

 

1” spacer will lift front 2”. So you probably want a 1” block in back. Post pics

 

I have a 1/4" spacer on the driver side to correct the lean as well.

 

I that pic the front doesn’t look high.

 

Looks fine