1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Pelfreybuilt steel hybrid install on my 2012

Discussion in '2nd Gen. Tacomas (2005-2015)' started by Tof-Corey, Mar 3, 2019.

  1. Mar 3, 2019 at 6:33 PM
    #1
    Tof-Corey

    Tof-Corey [OP] Well-Known Member

    Joined:
    Jan 17, 2019
    Member:
    #279655
    Messages:
    138
    Gender:
    Male
    Concord. CA
    Vehicle:
    2004 silver double cab
    KPD60/14B rear
    I was lucky enough to pick up a leftover pelfreybuilt hybrid bumper. After coating it with vht roll bar spray paint I finally got around to installing it went fairly smooth except that I can not figure bnb out how to utilize the additional bracket I can't get it to clear the studs nor clear the bumper without getting out the grinder. Didn't wanna do that until I asked you all for insight!

    IMG_20190110_125601_471.jpg
    20190302_162034.jpg
    20190303_163443.jpg
    20190302_164559.jpg
     
    Johnny DemonT likes this.
  2. Dec 26, 2019 at 2:54 PM
    #2
    Tof-Corey

    Tof-Corey [OP] Well-Known Member

    Joined:
    Jan 17, 2019
    Member:
    #279655
    Messages:
    138
    Gender:
    Male
    Concord. CA
    Vehicle:
    2004 silver double cab
    KPD60/14B rear
    Bowman lake

    20190706_120953.jpg
     
    Johnny DemonT likes this.

Products Discussed in

To Top