1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Light Racing UCA installation video & side by side comparison

Discussion in '2nd Gen. Tacomas (2005-2015)' started by freedomriding, Sep 21, 2015.

  1. Dec 29, 2019 at 1:24 PM
    #61
    nd4spdbh

    nd4spdbh Well-Known Member

    Joined:
    Oct 7, 2013
    Member:
    #114055
    Messages:
    14,595
    Gender:
    Male
    SoCal
    Vehicle:
    13 DCSB TRD OR v6 Auto
    You look to be good.

    Those look to be the Half tubed Half Forged SPC arms that have had the retrofit Xaxis joints installed. I JUST did this upgrade (xaxis joints) on my half tubed half forged xaxis arms and i ended up using the OEM dished washers to create more clearance between the edge of the outer xaxis joint and washer. (Dished out so the outer edge of the washer was further away from the UCA).

    In fact the fully forged arms with xaxis joints preinstalled tell you to use the OEM washers as such.

    ONE THING, do yourself a favor and loosen the nut completely, take note if there is a gap between the xaxis joints and the strut tower. if so get a small m14 washer at the hardware store to take up this space so you arent bending the uca inward.
     

Products Discussed in

To Top