FJ Cruiser Rear Axle Wheel Bearing for sale/Trade? Rear Axle housing, ELocker, Axles for sale

I recently replaced my rear wheel bearings on my 2007 FJ Cruiser (8"). I had a rear end noise, that I thought/hoped could have been a wheel bearing, but it turned out to be the ring gear failed (lots of HP, 35's, and a 4:88 don't survive long). I've decided to go with a Dana 60, but I need to reuse my backing plates (~$550). In order to replace the bearings of the rear axle, you need access to a specialized puller and press which I have. However, the wheel bearings are destroyed when you pull them from the axle...SO, my situation is this. I need new backing plates, but I hate that I have to destroy my new, less than 10 miles old KOYO wheel bearings to accomplish this. I may be able to help out someone in the central California area that is due for new wheel bearings.

To recap, I have a left and right rear axle complete with new KOYO wheel bearings, Toyota washer, Toyota retainer (what the oil seal rides on) and I can provide new toyota oil seals. This bearing kit was bought from a great seller on Ebay that assembles OEM kits for us at $300.

2 x 9030183002
1 x 4246060010 Koyo
1 x 4245060050 Koyo
2 x 9020844001
2 x 4242360050
2 x 9052041019
2 x 9031058003



(Generic picture from Ebay purchase of bearings, please note bearings are installed on my axles.)

Here are some axle purchase/trade options (must be willing to pick up local to central California Bakersfield to Fresno)
$350 - You remove your rear axles and I will exchange with you my axles with new bearings (less than 10 miles) pressed on and ready for bolt-in installation. Basically for the cost of new bearings, you can simply bolt on new bearings.
$550 - You can purchase my complete rear axles with new bearings. I can throw in the housing and third member minus a few teeth (the ring and pinion are damaged).

Also for Sale, willing to ship at buyer's expense
$330- elocker third member. Elocker is fully functional, ring and pinion are damaged.
$100 - bare axle shaft. Left or Right price is per axle.
$200 - Rear axle housing bare.
I am also willing to cut the axle housing in two and make someone a great bearing removal tool (partial axle with flange. Weld on steel winglets for use in press.
***$140 - Icon/Donahoe racing rear lift springs. Good for about 2+" over stock.

Time is of the essence as I will need the backing plates in the next two or three weeks. If this can't be useful for someone, I will have to wreck these bearings. Cash is preferred, but willing to also take Paypal friends and family. Please PM me and let me know if you have any questions or want specific pictures.