What Have You Done To Your 3rd Gen Today?

Man, I'm exhausted just thinking about how hard you've been working. If I was still a drinking man I'd have a beer or six myself.

 

Is the spray on the tires visible ?

 

In my neck of the woods we can't run those unless off road and if that isn't enough they have to remain covered when not off road. Not sure if the same rules apply to light bars, would hate to thinks so but it wouldn't surprise me.

 

Added a CX Revo that I found on line. . .

 

You'll find some info over here: https://www.tacomaworld.com/threads/bed-cubby-left-side-sport-mia.637147/page-2#post-21960505

 

They did away with it in 2019. Folks have added it, but it ain't cheap. Just buy a Tuffy and install it. Remember, measure 3 times, cut once.

 

Just got the same setup minus the bed stiffeners. Looks great

 

Nice and neat!
All those wires scare me to death!

 

Im assuming this is 3rd gen wiring, I've been looking for these for a year.. Thank you

 

Welcome to TW!

 

Yes, 3rd gen.

You're welcome.

 

Thanks man! Electrician for the past 16 years so it's almost as natural as breathing for me. Ha.

 

Another Toyota improvement!

 

Great images. What type of camera you use?

 

I used a Canon 7D Mark II with a Canon 24-105 f/4L and a DJI Mavic Mini

 

Here is a pic of before and after some elbow grease and a rag that you don't mind throwing away. I'm sure some tire shine will finish it off fine once I do a full wash.

 

Thanks. Gonna do this to mine to get me by till it's new wheels time.

 

Did you use the “dip release” on the tires before you sprayed the wheels?

 

My @MESO extended fuse cover arrived today ...but had to make a slight change to match my 2018 stock label .

 

Check out dipyourcar.com, they have a spray that you put on the tires that the overspray won't stick to