Florida B.S. Thread

Well, @Rob MacRuger and I had us a big ol' time at SW today. Thanks for getting me in half price. I'm still going to have to go back and get that damn shooters card...and probably pay for it again.

On the other hand, I was extremely pleased with my super cheap Panzer Arms AR-12. It only had one feed jamb and that was the second shot (ever), but performed flawlessly the rest of the session. It wasn't a stove pipe so I think I had the bolt carrier group so well lubed that the bolt cycled faster than the mag spring could push the shell up.

At any rate, the last five shots of the day @ 35.3 yrds yielded this one hole group...



I'm thus far officially impressed with this $400 shotgun. This was only the first 25 rnds though so time will tell.

 

Went to Green Swamp last week with a buddy. 1st of many adventures I’m sure

 

Wanted to pop in and say hello from suwannee county. I didn't go through all 4k pages but looked through a bunch. I see guns and tacos....I'm in lol.

 

So, come back to the states and my truck battery is dead. And of course left my key in the truck and only had my fob. Yay for pop and lock service. But onto better news, painting my bumpers this week after o clean my garage out some.

 

So, back stateside. Think i got everyone that offered to assist. I should be finishing the painting next couple days to have ready for install. So if someone is free on a weekend or after work (not sure how long it would take for 1 bumper since i cant fit both reaaly in the bed) id be down to pay

 

If your making the trip down to to installs. I'd just rent a small uhaul trailer to bring em down. Trident's helped me install mine. Can easily do both in a day.

 

True. Plus, i dont need the swing out. So it can all fit.

 

If you can’t find anyone closer than me and still need help I’m in.

 

If you head south just let me know what the date is Ill give you guys a hand

 

ayee my dawg lol

 

Been busy between sliders and my t4r and work. Still need to do some more to the cross member

 

I'm just curious is your front driveshaft supposed to be at that angle?

 

With a full width axle from a 05 f250 they sit further over. Normal for full width axles

 

Why isn’t it in yet

 

Hello from New Tampa! Same here, guns and Tacomas....

 

That was with the old harness and I don't trust it enough to run with it. I'm building a milspec racing harness from scratch lol.

 

What exactly is a mil-spec racing harness? Do you use ACU camo electrical tape and olive drab terminal connectors? Just from my experience, mil-spec and racing are two completely different quality spectrums. I'd shoot for race-spec.

 

Lol ewwwww acu cammo. Race spec wiring uses milspec wire and connectors. Although isn't milspec just getting the job done with the cheapest bidder?

 

Exactly