Input needed for fixing a fuel injector plug

As you can see in the picture, I pulled the wire out of the injector plug/connector. I went to the dealer and we couldn't find a match for the connector, only for the whole harness. I called a couple of wrecking yards and they would only sell the whole harness as well. I was hoping to find a pig tail type of deal that I could just solder on and go, but no luck so far. Id appreciate any input. Truck is an 08 2TRFE

 

Look on the face of the plug. Take your camera and zoom in. There's a number on it more than likely. With that, you should be able to get a repair wire for it.

Edit: @DaveInDenver can you help?

 

Or de pin and re pin the connector.

 

The connector housing for the V6 injectors is 90980-11875. I am 95% sure that the 4 cylinder uses the same connector. I'm also 95% sure the V6 connector is grey and the 4 cylinder is brown. I don't know what color that replacement housing is. I am 100% sure that the part number of the pigtail for that part number connector housing is 82998-12790. However, that pigtail is between $16 and $27, depending on where you buy it. Here's a much cheaper source for the 90980-11875 connector, however, you need to confirm with them that it comes with the pigtails. It says pigtail in the description but they're not shown in the pic.

https://www.bmotorsports.com/shop/product_info.php/products_id/2074

There are also a few ebay sellers that sell that connector with pigtails. Here's one.

https://www.ebay.com/itm/Scion-Fuel...r-Repair-End-90980-11875/133032479806?vxp=mtr

 

Thanks guys, that's what I was looking for.