2011 TRD Sport 285/75/16

Whats up guys
Just picked up an 2011 trd Sport
And immediately put on scs stealth 6 16x8 -25 offset 285/75/16 general Grabber atx
It has a 2”level kit
But still rubs pretty nasty, I took out the front mud flaps which helped a little
Any quick fixes for the time being?
I am going to get king 2.5 up front eventually, will I need to do uca and all that also?
I know king makes a whole 3” lift but I didn’t really want to go that route but if I have to....
Just any ideas? Or just trimming?

 

Specifically, where are you rubbing? That big of a tire typically rubs cab mount tab/ear on the frame. Typically requires a cab mount chop.

https://www.tacomaworld.com/threads/bamf-cmc-plates-cab-mount-chop.192527/

 

Mostly the inner fender, not so much the front bumper
I’ll need to double check to see that it does hit the frame
Even with lift she would rub then?

 

That is typical. It's usually the rear fender liner/cab mount frame ear and not the front.

It's possible that it doesn't rub with the lift for general easy driving around town at relaxed ride height but will almost certainly rub when the suspension is compressed. High chances to certain it rubs when offroading.

If you're considering UCAs and go with light racing/SPC, it is possible to use the LCA cams to move the lower ball joint as far forward as possible to move the wheel forward in the wheel well, then complete the alignment with the upper adjustable ball joint on the UCA. I have not personally done this on the Tacoma, but it was common on the Nissan frontier and xterra to fit a 285/75R16. The concept is the same on the tacoma: https://docs.google.com/document/u/0/d/1GajnzvyucNyEdhRrOrNr3Xz-1DO7SsdMu-lV4i56ifg/mobilebasic