What Have You Done To Your 3rd Gen Today?

Umm I could of swore anything on the threads was a no no. If only for the torque spec I doNt know. Now I do the mating surface for sure

 

Congrats!!!!

 

Is that some kind of "fancy" running board? Tell us about that. Also, what is special about the tub from the air filter to the intake?

 

Vinyl wheel decals until I get my wheels tires and lift, Meso puddle pods, Meso ultimate turn signal, cement insert letters, MESO blacked out kit, Cali raised tail lights. Not all done today but over the course of about two weeks. Can’t wait to get more done to it, it’s so addictive once you start!

 

May I get a link please? How difficult was it to take on the Toyota emblems?

 

3" Exhaust upgrade with rerouted , lower cat delete MBRP & AFEpower!

 

I came to Tacoma after years of driving BMW

what camera is that? How did you attach it to the grille?

 

what fire extinguisher is that please?

 

AFEpower?

 

Got a fuel pump safety recall there other day. Might explain my fuel cut on hard throttle between gears.

 

Please forgive my ignorance, but why are you hard on the throttle between gears?

 

Because I drive it like I stole it on all my vehicles. Mainly what I was referencing was, when at WOT (my truck is an auto) while accelerating onto on ramps, passing, or getting off the line quickly, is there will be fuel cut/major pause in acceleration, to which is so severe that I have almost been rear-ended at times, or the vehicle I am passing will actually gain a bit on me, before the next gear kicks in and I speed away from it. I should make a video of what I am talking about for better clarity.

 

Studder on acceleration? If so there's supposed to be aTSB for the automatics that involved reflashing the computer.

 

I had the same problem so I just connected it with the headlight. I spliced the wire and connected there. Its only on when I turn on the headlight

 

Wth is that silver thingie??

 

I did this today! Also made a video about it

https://youtu.be/Ps6rfCgEK9o

 

those are pretty bad ass

 

I cringed when you banged the bulb on the paint.

 

They look good but I just can’t with the labeling in the light.

 

Just installed my low beam LEDs. Didn't realize that they had mini fans on them to keep them cool. A lot louder than I thought they were going to be.