What Have You Done To Your 2nd Gen Tacoma Today?

Thanks. Pricey. It should be good.

 

I am a firm believer, you get what you pay for. This is a high quality ABS plastic product.

 

Usually true.

 

Finally bath time

 

Got the security bolts on though not sure how effective they’ll be

 

Well if that doesn't work. There's always the alternative...

 

I`ve read that a lot of you are installing Fumoto valves. My question is how tight (torque?) do you use when you install them. Don`t want to do the tighten until it strips then back off a quarter turn.

 

I’m also curious, thinkin bout doin this mod soon

 

Maybe both

 

how do you like that dashcam? does it have a rear cam too?

 

try the Hi Lift mounting kit. They make one for the TACO

https://hi-lift.com/hi-lift-bed-mount-for-toyota-tacoma/

 

I can't recall if there is a torque spec. I tightened it by hand and just used a socket to snug it down, just like the bolt it is replacing. Love it. Oil changes were easy enough, with the valve, its even easier!!

 

Still drops down too far, I run a sleeper set up

 

+1 it's great! Just snug it down, you'll know when its good enough.

 

where did you get the bracket???

 

sorry to hear that. I have to modify one of my bed stiffeners since I got the HiLift Extreme 60 inches. I have a DBC=short bed. Hopefully, you will find a solution...

 

If the fumoto valve doesn't come with a torque spec number I would use the same torque spec as the drain plug. I think Haynes has it at 32 ft-lbs. Searching TW, most responses say 30 ft-lbs so somewhere in that range will work.

 

Quick pic this morning of last nights hardwork. BAMF front bumper installed. Just need to get alignment done today now that I got the ride height situated with the new 700# springs and new Dirt King UCAs.

 

I hope I don't start a fight, but 245s or 265s, what does everyone prefer? (75R16)