Photos of cut/trimmed front bumper?

Yeah, i'm not wanting to get another bumper... and if i ever did, it would be a tubular, minimal type thing..

 

I was more posting the reference for where to cut. There’s a thread somewhere for people who just made a similar cut without actually having the stage 2 bumper.

 

I have their rear bumper. Solid dudes.

 

Ah, gotcha, thx

 

Good to know

 

Every day i ask myself if i really have the balls to chop my 2019’s bumper to fit the C4 hybrid. I tell myself yes, but i have my doubts

 

If thats the bumper youre wanting....Send it... Its really not bad, man... Measure twice cut once

 

Wait till you do a HC rear bumper. Talk about stress on a new truck lol

 

No kidding HC Rear bumper on order... Between front/rear bumpers and the snorkel.. you'll grow a few white hairs lol @boston23 seriously, its not too bad

 

Its a piece of cake!

I had Demello install front. I could have done it but was on a timetable to be ready for a trip .

 

looking good, brotha

My poor truck is pretty weighed down in the front with two northstar batteries, full BAMF armor, low pro bumper and winch. I'm trying to avoid adding anymore steel to the front... I want to trim what i have... last case scenario, tubular...

 

Yeah i have a ton of weight with full Mobtown steel skids, fuel skid, the winch up front and the swingout with dual jerry cans , RTT. I just have the 1 Northstar 31M . 700lb Icon front coils took care of the weight up front and custom Deaver 900lb leafs took care of the rear! All running on 34" Cooper STT MAXX. Added 4.88 gears and OVtune and i hope to have OVtune Twin Turbos when available!

 

Holy shit

 

I cut mine. I made a post about it. You can probably find it in my history.

 

Whewww this is a good lookin cut!

 

Digging that. Maybe cut center black plastic off and make a stubby prerunner bumper like a lot of chevys do.

https://dirtkingfabrication.com/products/prerunner-front-bumper-dk-635920

 

the wheel liner behind the fog light was taken out completely?

 

It's cut up to this point. Eventually I'll make a custom liner to fill that opening into the engine bay. But I may be doing a bumper sooner than I thought so I'm going to hold off.

 

hmmm, gotcha.. Thx for the photos. I just realized that i will have to add a stiffner to keep my bumper from flopping in the wind if i follow this cut... The way the bumper was cut to accept the c4 fab bumper, the only thing holding things together is a little arm / tab that holds this bottom section from flopping... I can totally make something...NBD. I've yet to catch the front bumper on any rocks, I've come close though... mostly on approach and sliding off a rock... thx again for the photos... def going this route.

 

@Outdoorsy_Yota