Me-so Total tail stage 1

So I installed a stage 1 kit from meso customs on Friday and today I was driving and had to back up a bit at the light so then I noticed when I put it back in drive and turned on my left turn signal it began to hyper flash. Any of you experience this?

 

Check the wires. Check the connections make sure theyre not lose or something.

 

Will do but I don’t think anything is loose.

 

Some people had to message Meso and get the resistor, as this was not happening to all trucks.

 

Will check all my connections then if nothing then I’ll contact him.

 

Yeah, i said the same thing when installing my front camera, i checked everything and turns out one of the ground wire wasnt properly connected.
Or get a hold of Meso.

 

https://www.tacomaworld.com/threads/meso-total-tail-light-kit.594535/page-232

tons of info in this thread

 

If I shift into reverse with the signal on it will hyper flash and stay that way until I turn the truck off and back on, then it goes back to normal flashing.

 

See that’s what mine did. But I didn’t have to turn it off it just changed after a bit

 

You were probably just more patient that I was.

 

It's normal. Reverse and turns use the same bulb. Don't use them both or you'll just have to live with the rare occasion that u have to. Resistors only help when u use the turn signals like normal and they hyper flash.

 

Mine hyper flashed when in reverse and using the turn signal. Contacted Meso and he sent me couple resistors. Installed the resistors and it fixed the hyper flashing,