1/4 inch Top plate spacer with 6112s??

Before you jump down my throat and tell me you don’t need a top plate spacer with 6112s.....I know....hear me out. lol

2019 Off Road DCSB 4x4

Have some SCS 17x9s -38 and with 295/70s sitting in my garage ready to put on. Just finished CMC and pinchweld.

What I’m trying to determine is - since I’m trying to stuff a little extra rubber with a little extra neg offset under there - will the standard 2 inch lift from the #5/#6 on the 6112s be enough.....or should I set them at #6/#6 and put a 1/4 inch top plate spacer on the drivers side to get a extra .25 to .5 inches out of the lift.

I don’t mind trimming - I just want the trimming to end at some point. (Keeping stock front bumper)

Anyone have input??

 

I ran a 1/4" top plate spacer on my toytec 2.0 set up, worked great