LOOKING FOR ECGS PULLER LOANER

Hey guys, I just installed 2nd Gen Billies, OME 887's, SPC UCA's, and Icon AAL to the truck and I am having the Clamshell Vibe. So I will be ordering the ECGS bushing, I would rather not spend $45 on it and would be very appreciative if someone would loan it to me, or sell it cheaper! Thanks! Located in South East Louisiana

 

Location would help folks know where your at.

 

https://www.tacomaworld.com/forums/regions.36/

 

Most autoparts stores loan specialty tools.

 

I had luck locating a loaner by posting in the classifieds. There’s a lot of good people on here. I bet there is someone on here from Louisiana that can hook you up.

 

https://www.tacomaworld.com/threads/ecgs-bushing-tool-needed.666453/page-2#post-23540738

 

Haven't yet tried it myself but read on a ECGS bushing thread that someone said to rent a blind hole puller set from O'rileys and use that. Also they recommended to rent a bearing race and seal driver set too. I believe you can rent tools from them for free (may be wrong about that), but you just have to return them within 48 hours. Hope it helps!