ecgs bushing corroded

Had this sitting in my shed awhile.

Can i still use or just rebuy?

I tried cleaning it off but feels like i might be damaging it.

 

Its Friday and I don't trust you!

 

Is it deeply pitted? If you're cheap (like me) I'd spend some time on it with scotchbright, clean it up and reuse it. But that's me

 

0000 steel wool or scotchbrite pad and blue dawn. And yes it had to be the blue dawn.

 

If it's deeply pitted I wouldn't use it. Otherwise lube it up and stick it in.

 

hard for me to say if its deep or not but I would say it has pits.
too important and cheap of a piece to skimp out so i guess ill just rebuy. booo wanted to install today.

Thanks jesus I checked all my equipment before i had an open axle in front of me.

 

^^^^

looks like a light surface rust rust, will come off easily.

 

Lay scotch bright on a work table and hold the two outside edges with your fingerand thumb. Drag it on the pad and roll it. That looks so superficial, if I didn't already have one I'd buy that off you lol.

 

ill give it a whirl

 

Also wd-40 helps with the scotch brite, just about the only thing it's useful for. What does the id look like? That is the bearing for the rotating surface, at least from my understanding.

 

Mine was the same way after sitting for awhile. I cleaned it up a bit and shoved it in.

 

Looks like it shrunk

 

I shower with blue dawn. It’s the perfect soap.

I mean. I have a 5 gallon bucket. Why would I wast my time and money with bs soaps who spend more on goofy marketing than on their product.

 

Thank god for the ignore button

 

If we’re in the same thread, I’ll just pm you my shitposts.

 

Dumbass

 

Came out ok might use it

 

Felt cute, might install later. I would. As long as u didn't use sand paper or something that's changed The geometry

 

Just the scotchbrite heavy duty green sponge things