What Have You Done To Your 3rd Gen Today?

I've replaced mine all ready.

 

Thanks - it's close to my place so I'll roll down there tomorrow

 

Was this hard to install?

 

Finished puddle light and footwell illumination on passenger side tonight. Also added a blue LED light in the door pockets.

 

Installed 255-75-17 duratracs today and finalized the anytime backup camera mod yesterday.

 

What brand Shackles are you going with? I just bought me this setup but Im having a hard time getting the right Shackle to fit

 

These didnt dit my demon ring. I think mine are uneven

 

Adjusted OEM fog lights I installed on my SR. Used scientific method, tools required:
1 - son with long arms to reach down and adjust lights from top
1 - garage door
1 - darkness
Steps: adjust until both fog lights provide even illumination on garage door, and slightly overlap the bottom of the low beam pattern. I have the full "measure this, measure that" instructions... meh. This will do for now.
Bonus- ordered some Hella H11 Xtreme Yellow bulbs for the fogs.

$21 HELLA H11 YL Twin Blister Xtreme Yellow Bulb (12V 55W), 2 Pack

https://www.amazon.com/gp/product/B079VYZ2TP/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1

 

i don't have that on my windshield, unless i'm looking in the wrong spot?

or what about all the chrome buttons on the headunit? i replaced the volume/tuning buttons with the RAV4 ones to get rid of some of the headunit chrome.

and then there's the sunvisor silver screws that need replacing too...

 

Nice!! How’s ya do it? Disassemble the wheel or just pull off the emblem?

 

I didn’t have to do anything really. It’s an overlay from @AJT DESIGN. It just goes right over the existing emblem. Super easy!

 

@LSUfan1975

I hate that they were closed. At least you know how to find it!

The wind wasn't blowing so the Whirligig park was disappointing too.

 

I do believe it was a facetious reference to the rear view mirror

 

The ones Rob lists on his YouTube video for $19.99. They seem good.

 

I couldn't get mine on with both supplied washers either. I used just one washer then went looking and found this. It comes with thr thick and thin washers. Currently I have 1 thin and 1 thick washer installed and they fit perfecr with no slop or rattle. There was no rattle with a washer on just one side either

If you mean the pin didnt fit then your backets arw messed up cause 7/8" pin is what should fit

 

sheesh! that went right over my head

 

Finished up the Fox 2.0 install today with the fronts. Raised it up 1 1/4” and tomorrow it goes in for new wheels to be installed.

 

After 9 weeks of driving around with a busted up front end this finally showed up.

 

Thank you for the pictures. I’m pretty sure I can’t get these to fit with my pelfrebilt skid, but with your pictures, I can check tomorrow. Thank you