3” wheel spacer on 3rd gen

Post pics of your 3rd gen with a 3” wheeler spacer, I need help deciding what size I’m gonna rock

 

Roll that Motha out!

 

What are the options?! Sir!

 

Looking at 2” spacer, 3” spacer or just a new set of wheels but I haven’t seen what a 3” spacer looks like on a Tacoma, that’s why I made this forum

 

Brands? So which stock wheels you got?!

 

About like this

 

I’m lookin at bora for the spacer and I got the stock trd off road rims

 

Any other mods in mind?! Front lift and removing leafs from the rear?!

 

I already have a 2 inch suspension lift and for the wheels I just want a clean offset, I might just save up and buy new rims but the rims I have rn are already good for off-roading

 

1.25” Spiders or Boras... don’t go 3, don’t go 2... keep it simple! If you’re on stock tires you’ll be fine!

 

Ok, stock OR wheel is 16x7 +25mm. A 1 inch spacer will put the wheel 1/2" past a 16x8 + 0 wheel which is a little past flush with the fender. A 3 inch spacer will stick out 1/2" past a 16x8 -25mm wheel (like an SCS) or a few inches past the fender.

That will give you a general idea, with the caveat that it starts to look pretty weird when so much of the tire sticks past the fender. I think the 1.25" hubcentric spacers will give you the look you want.

 

This.

 

Here's mine back in the day with 265/75R16s with TRD OR wheels with 1.25" spacers. Looks stuffed and more aggressive than stock.

 

Could sell your stock wheels and get aftermarket ones. My Procomp wheels were $90 each. I think spacers are a risk not worth taking. But that's IMO.

 

On the record... You started it!

Spacers are fine if installed properly.

 

Define installed properly budday!

 

You know I don’t trust you right?! Cmon! You ever turned a wench?! Define tork oz’s!

 

You don't have to trust me. Just don't trust that spacer to stay in one piece.

 

Oof. What’s what I have to say about that. Looks like a T4R though