Roof Drip Molding

I have a 2012 Tacoma 4 door. Car wash ripped off one of my roof drip moldings and tore loose the other one. Local parts stores can't order them. Called the stealership and they want $108 EACH side.

What has everyone else done to replace them? Suggestions and links appreciated.

 

Can always try to buy a set from a local member, maybe check eBay?

 

Plenty of dealers online selling for less.

 

post up a wanted add in the classified. I lost one at some point on the 395 in an 80mph sidewind. Member sold me both sides for like 40 shipped.

 

Got mine at local pull-a-part for like $30 for both

 

You can get them online for less than $50 Each.
There are a few clips it snaps into. Check and see if they are still in the truck.
If not, you’ll need those also.

Mine came loose on the passenger side up front. Just the front edge near the windshield.
I snapped it back in. When I had the windshield replaced, I mentioned it to the guy.
Just in case he needed to remove. He said he sees it a lot. He put some adhesive on it for me.
“So it would come loose again” So far, so good.

Others have used 3m double sidead tape. But you need the type for automotive trim.
Not the general purpose found in most retail stores.

If mine ever comes off again, I’ll use some adhesive all the way down. Then snap it in.