Ripped air intake

So I’m doing my valve cover gaskets and I look and see that my air intake is ripped at the seam where it meets the throttle body. I’m surprised my car was running fine this whole time. Can I buy an eBay replica or should I go OEM? How much would a new one cost? Thanks in advance!

 

I bought mine from my dealer I did not think the cost was to bad .

Been a few years

As long as the Ebay one works and has all the ports where they need to be.

Does not end up 1" to short

 

Yeah I’ll double check with Toyota before I buy a eBay one! Thanks

 

I'm looking to sell my old intake tube. It has a Toyota OEM 4tunner boot.

 

I'll post a pic of it off the vehicle if your interested. $70 shipped

 

what are you asking for it?

 

See post above. Boot is about 3 years old.

 

Make me an offer I can't refuse.

 

I first bought an Ebay boot. It ripped after 2 years. It dried out really fast.

 

p/n 17881-62170 for my 02 3.4 double cab, was $102 shipped from Camelback in April 2019. I feel that the legit toyota rubber stuff lasts longer than the off the shelf stuff, but that's just personal opinion.

 

First hand experience it last longer.

 

Here's the list of parts less tube. With cheap ebay boot.
https://www.tacomaworld.com/threads/new-intake-tube.482001/#post-14716695

 

for certain years there is an updated boot that requires an adaptor for either the resonance chamber or another fitting been awile so I am not 100% sure. I would check before i buy the ebay one.

 

That scene in The Godfather comes to mind whenever I hear this phrase.

 

Get the Airaid setup.$150
More room in the bay. Bit more intake sounds,
And yes OEM will last longer