*Sold!* Bed Drawers for Long Bed 3rd gen Tacoma (and 2nd Gen) - $250 OBO

EDIT: SOLD!

Hello TW,

I am selling my homemade bed drawers that I used for storage, a camp kitchen and a sleeping platform in my 2016 ACLB. I built these almost 2 years ago (check out this thread for my build pics: https://www.tacomaworld.com/threads...-storage-systems.424709/page-59#post-18754514 ).





They work great and and use ZERO fasteners to install in a long bed Tacoma. The frame sits in place snug between the wheel wells and flush to the back of the bed and tailgate. no rattling or moving around. The drawers are mounted on a series of roller bearings with a steel box tube attached to the drawer. To remove the drawers, simply just pull them out. At full extension, the tailgate helps hold the drawers flat and prevents the drawers from tipping the whole system out of the truck. When fully loaded and one drawer out at a time, no tipping occurs.

One drawer has removable dividers that provides the ability to compartmentalize your things as needed. The bottom of the drawer is painted and coated with flex seal to create non-slip surface to further help prevent excessive movement while moving.



The other drawer has a large storage area (no dividers) and an open front area that is set up for a cooking area. This area also has a custom bungee tie down set up to securely hold down any type of grill, griddle, etc that can fit in the space. This cooking area is painted with a high heat BBQ paint to prevent damage from heat from a cooker.





Each drawer has a latch that is lockable, but there are still ways to get into it, so it is not theft proof. It is not so much for security as it is to keep the drawers closed in the event I am driving with the tailgate down.





The screws in this pic are temporary. They have been replaced with smaller ones so there is no poking hazard anymore!

The top platform is in two symmetrical pieces and cut to a tight fit and sits flush with all edges of the bed. It also sits on the drawer frame and the top of the wheel wells to ensure there is no sagging when laying on it. I am 6' and 200 lbs and with gear, a dog, etc, I never had any creaking or sagging. It is very solid! The platform is painted and covered with an outdoor carpet. No mold, rips, tears, etc have occurred to this platform in almost two years of being in the truck full time (keep in mind, I had a topper the entire time).

Looking for $250 or best offer. Pick up only. Willing to meet within a reasonable distance to make the deal.

THIS IS ONLY FOR THE DRAWER AND PLATFORM SYSTEM. NO CAMPING EQUIPMENT INCLUDED!

 

Nice setup! Wish you were a little closer to south MS! GLWS

 

Very nice.
I too wish I was closer but I'm glad I saw your setup.
I'm doing mine very soon.

 

How difficult would it be to cut down for a short bed?

I am in San Antonio would be interested in buying.

 

Really nice job, if I had a cap I'd be all over this.

 

Not too hard. The drawers would need to be trimmed from the back side and have so you don’t have to have mess with the handles.

 

Bump!

 

Bump!

 

Any chance you’ll be driving to SoCal soon ?

 

unfortunately, no...

 

Bump!

 

I’ll be moving to Georgetown on the 2nd. If it’s still available then, I’m definitely interested in buying it.

 

Sounds good. I'd easily be able to meet halfway. I will update this thread if it sells. If you move here and there's no update, hit me up.

 

Awesome! Thank you so much!

 

Sold!