Ready Lift SST 3"/2" Body Lift

Hope everyone is doing well. Next week my 2020 Tacoma TRD Offroad is getting the Ready Lift SST 3" front 2" rear lift kit installed. I'm having a killer time deciding on what tires to go with. In the paper work I got from Ready Lift it says that the lift was designed to fit 33"x11.5" tires with a 20"x9" wheel and a +6 offset. So is their any reason that 285/75 R16's wouldn't fit on factory wheels with a zero offset and not hit the UCA? They are a little less than 33"x11.5". I've looked through the wheel and tire thread but it's hard to see what people have done with a 3" front lift.

Thank you,
Matt

 

I’m in the same boat but with a SR5. Hopefully someone can let us know soon

 

Wheel spacers are usually needed if using the stock wheels for 285s or aftermarket wheels with some negative offset. The stock wheels are 16x7.

 

285’s will fit just fine.

I ran that like on my 2016.

 

I got the lift installed Friday. I went with Method standard wheels. 16x8 zero offset. I have zero rubbing.

 

Looks great

 

looks good man, probably could go even bigger on the tires
I had this lift and all I can say bad about it is that the truck rode a lot rougher but the good looks was a great trade off.

 

I have some 1.25 g2 wheel spacers if needed

 

I have the same 3/2 Ready Lift installed on my 2017 TRD sport DC. Running 285/70/17 Nitto Ridge Grapplers on 17x9 Fuel wheels with a zero offset. Only had to trim a small amount from the front air dam. No issues with rubbing or clearance. Hope that helps.

 

So you folks with no rub......

Does this include some rugged trails that fully flex the suspension?