Harbor Freight tools thread.

So I noticed the 20% coupons say not applicable to Central Machinery. But does that apply to Central Hydraulics?
Looking at the hydraulic press...

 

If it doesn't, the 15% off a couple posts above will definitely work.

Edit: looks like it's good on central hydraulics

 

Quinn socket set I bought some time back on sale, excellent quality I rank up there with craftsman. Most were 6 point with a few 8 points. Fine case with sockets well secured.

 

I actually own a cordless hammer....

 

I had to....

 

I like this tool. For every nut you loosen, you open a bottle of beer!

 

I bought this set too. Not bad for the money

 

I’ll have to check that out this weekend.

 

Too bad it's not 10mm.

 

You'd never be able to find it to open your beer!

 

the sale last weekend got me

 

Nicely done.

 

FTFY

 

Put some free tool holding magnet bar to use.

 

Update on the Badlands Apex 12k winch.
Pulled a prerunner up a steep, wet, rocky incline and pulled a ford ranger 3 times in one day. Winch never missed a beat.

 

I almost jumped on that drill press, the bench grinder would be handy too. I did get one of those Braun lights though, it's been useful already!

What have you done with them so far, how do you like them?

 

The chicken looked pretty good, maybe a bit more crispy than I'd prefer, but not bad!
I could just be hungry though, no breakfast thus morning.

 

Yeah I didn't think about the heat gun making the skillet hot too and so that bottom side nearly got a double dose of sear. It is some of the best chicken I have eaten no lie... Especially in the not deep fried chicken department

 

So far I’ve used the drill press to drill out spacers to acts as bushings when I fixed my trash can, and for the $50 or whatever it was it’s sweet!

Before



All fixed

 

My dad has had that drill press for yrs. Its not bad. Not as nice as the 50yr old one my grandfather gave him, but decent. Allows us to have multiple drill bits set up at once. My only semi gripe is adjusting the platform under the bit is a bit clunky.