What Have You Done To Your 2nd Gen Tacoma Today?

Yes, me too in my Ranger. They were awesome for their day. I've installed 1,000's of them.

 

No pictures but did end up getting my brakes done tonight... rear diff fluid changed tomorrow

 

Whatever you say. Suggesting Clark didn’t know what he is talking about is like saying you like AR rifles but that Eugene Stoner was a hack. But hey, the internet is full of opinions.

 

Finished my homemade roof rack Installed some cheap Amazon light pods on the back.

 

What a difference maker they are. I wish I had done mine sooner

 

I took a ride to the dealer yesterday to ask about the frame treatment. The service writer said they are still on hold.
The dealer I went to is "trained" and they have the equipment and product to do the frames but haven't done any yet

I'm kind of hoping I develop a hole so I can get a new frame.

I also took a ride to pick up my boots. Ordered them at DSW and had to drive 45 minutes to get them when I wanted them to ship to a DSW that is less than 10 minutes from my house.
The navigation worked perfectly as far as the speed limits, reroute due to traffic, weather and previous destinations. Bluetooth also worked flawlessly as I had a call come in during my drive.
The location is slightly off so I need to calibrate that, the beep also could be louder but I don't think that's adjustable.

I downloaded the navigation owners manual from Toyota. I'll look through it so see if I can change some stuff.

I also saw that the time auto adjusts for time and daylight savings

 

Where did you find those seat covers?

 

Found them on Amazon. The company is INCH EMPIRE. Install wasn't too bad, but I did end up unbolting the seats which made it easier...

 

Installed a aFe Magnum Force Cold Air Intake. Took me about an hour and change.

 

A little sandpaper might help with that. Idk, rust isn't a problem in the desert.

 

About to install Banks Monster Exhaust System to my Tacoma.

 

Installed my RCI front skid plate.
I think I'm going to remove the 2 front bolts and paint them.


Gas tank skid is next.

 

FREAKING ROOKIE MISTAKE!

Changed my rear diff fluid and was in a hurry and forgot to put my crush washer back on.

Note to self dont do stuff when you have time constraints or get up earlier...

 

I still need to install my three RCI skids. I already have the gas tank skid installed.

 

Installed the remote start harness from the ignition to the remote start.
I had to rewire it because I had too many splices in it (more chances for failure). I also ran it a slightly different way so I'm able to reinstall the bracket and dash panel below the steering wheel, before I wasn't able to.

Ordered another box (36 sq. ft.) of Noico sound deadening material. I should now have enough to do my floor, rear wall and possibly put another layer on the roof.
https://noico.info/products/noico-black-80-mil-36-sq-ft-car-sound-deadening/

 

beat the pinch weld back finally



MILSPEC battery terminals and 6 gang auto dimming switch panel from Amazon

 

Cleaned the dam blower resistor connector again. Pia

 

test fit the new 12+ scooped hood to make sure it would clear the engine cage.

and almost done with the new wheel wells!

 

searching AliBaba for Tacoma parts was a mistake

 

They do that do avoid copyright, it’ll come spelled correctly. Still funny tho