What Have You Done To Your 3rd Gen Today?

Alright, update time, yes! They were not installed properly (go me!). I loosened them up and realized I had gone up over the lip of the bumper when fitting them and tightened it down like that. It was a long install, basically because I was afraid of breaking things so I went very slowly and thus was pretty done by the end. Anyway, long story longer, I've adjusted the fit and it is MUCH better now, chalk it up to user error.

 

I was about to go out in the garage a take a picture of mine for you and it dawned on me that my truck is still in the shop. Of all the things in my life I've lost, its my mind I miss the most.

 

Hahaha. Thank you for the effort anyways man, I appreciate it, and I’m right there with you. Still lookin for a picture of that finicky connector. I wish the wiring and wire protection was a bit more heavy duty on those tiny connectors.

 

DMM mount. Can find in 3rd gen forsale thread.

 

Yea they are pretty thin. Hopefully someone will get a picture for you. Good luck with the repair. Sounds just like something that would happen to me if I tried to replace the plugs myself.

 

Picked her up today! 2021 DC OR MT

 

I have Rigid D series pros in selective amber, hyper spots. Great output and enough power to handle some pretty thick fog.

 

Puts some lights on my rack and drove through magic mountain...

 

Installed a light bar and Cali raised fogs light replacement. Thing got bright!

 

Technically, 'things I did to the camper shell on my 3rd gen'...

 

Is that panel as flexible as it looks? I’m considering solar solutions for my eventual soft topper.

 

yeah it's a generic 100w monocrystalline flex panel. I wouldn't use it on a soft-topper.

 

I haven’t had a time yet where I needed to try them out. I look forward to hearing responses from real world experience as well.
I wouldn’t hesitate to try them out when the moment arises though.

 

I got my 2nd KTJO "one click" window switch installed on rear passenger side door. It was another 5 minute install.

Only real tool you need is a plastic trim removal tool:




Box contents:





Popping the window trim off:

https://i.imgur.com/adl4dFH.mp4


Factory wires connected under the trim panel:



Wires being put into place:










Video of window going up and down:

https://i.imgur.com/a7WHgZd.mp4


And I also put a second string of raptor lights on the lower half of the grille with @runnin4tacos DRL connector. It looks "ok," but not really happy with their placement. Tried in about all the slots I could and these 4 were about the only that would work.

 

Thank you!!!!! I seriously appreciate it! If you’re ever in Denver I owe you some beers!

 

Installed back rack and window tint on the back windows. Also cleaned up a couple of rusty brackets in the engine bay.

 

They could, but from what I read here they leave an adhesive residue behind to be removed. Probably not hard to do at all. This method was just my preference.

 

Drivers side sucks, I ordered intake gaskets and pulled the upper intake manifold off. 6 extra bolts but way easier than dealing with tight spaces and sharp plastics lol

 

All my dealer has are RAV4s and Tacoma SR5s with no name lifts paired with Fuel wheels.