What have you done to your Tacoma today? 1st Gen Edition

Hey guys... long story short my truck was stolen last night... & wrecked i had huge plans for it i had a 5in over long travel kit for it... along with 2.5x10 coilovers the whole package if anyone is looking to make the switch from stock or mid to full blown LT let me know i need whatever $ i can get from my vehicle being stolen insurance not covering it... contact me at 909-553-9031 thank you.

 

I had a CEL. Scanned it and it came up as P0031
Heater control circuit low
Bank 1 Sensor 1
Needed to replace my upstream
O2 sensor
I have an auto so the
Part# was

$145 234-9001 Upstream Air Fuel Ratio Oxygen Sensor with 10.6” 4-Wire Harness, for Auto Trans Equipped Vehicles

234-9001
I replaced it and now the
CEL is off.
I’ve driven around 200 miles so far and it’s still off.
Hope that was it

 

Good work! I need to do the same thing. Where'd you get the sensor and what was the final cost? Having a hard time throwing a hundred bucks at something so silly, but that's what it's looking like...

 

Installed a magnet mount!

All worked out perfect and feels OEM. Because of the angle and location it looks like the phone is just floating there from the driver's perspective. 10/10 would do again.

 

Autozone had it for $138.00 then auto anything price matched and dropped it to $128.00 so I went for it.
Them I happened to be on Walmart.com and they had it for $125.64
But sometimes you never know if it’s fake or not.
But I was happy with what I paid and what I received
I have to add
O’reilly’s was charging $180 for the same Denso part

 

I’ve attempted that job but those nuts were so soft they completely rounded out. I gave up on that job...coincidentally my CEL went away shorty after and never came back.

 

I got lucky.
Although I didn’t have an PB Blaster. I ended up spraying WD40 on them a day or two before the job. Lol!
My truck was originally sold new in North Carolina. But has been a CA truck most of it’s life. I’m the 3rd owner and it has 282,000 miles on it now.
When I was taking the nuts off. One came right out. The other one was a little more difficult and I ended up taking the whole stud out. But when putting it back in. The stud threaded in and tightened all the way down

 

I have an abs module if you are interested in it message me.

Did you have the 5" installed?

 

How much for that passenger mirror

 

ARB sent me a set of lights for my troubles,



I think I like the black better than the red.

 

Installed some new headlights and some led corners and LED rear turn signals.

 

added a spaceX logo to my camper shell

 

Started working on the audio project.

https://www.tacomaworld.com/threads...stall-and-interior-mods.696445/#post-24637717

 

What size vacuum tee would I need here?

 

I’m also trying to figure out what this plug is for.

 

Wow truck looks amazing! what size bedsides and front fenders?

 

4wd indicator light.

 

Repainted the grille craft mesh

 

Nice! I'm putting in a system soon too. Just need a fuse

 

Nice.

What were the troubles?

That bad boy allows you to have 2wd low when not plugged in.