Storage clean out- 2nd gen parts

Doing some spring cleaning, and here are some parts I found. All prices are OBO, local pick up preferred in Dallas, TX.


OEM LCAs off 2005 Tacoma- SOLD
DCSB driveshaft (needs rebuild)- SOLD

1.5 inch Bora wheel spacers- SOLD

Welded BAMF shock relocation- SOLD

New 255/85/16 Cooper Discoverer ST (can include OEM wheel as well UNmounted)- 50 OBO

 

What configuration did this come off of? Auto or manual trans? and 4 banger or v6? im interested possibly depending on specs

Edit: i think they only offered 4wd DCSB in the v6 flavor so im guessing it's a v6 driveshaft. Let me know if this isnt the case. I needed one for a 4 cylinder 4wd. GLWS

 

I will take those wheel spacers if you would be willing to throw them in a flat rate box and ship them to me. Lemme know! Thanks!

 

As. Am new to Tacoma’s. What are the benefits of spacers

 

Correct. It’s a 4WD manual drive shaft

 

PM me. I should be able too if you pay shipping

 

At this width, they put your tires out a little wider, can be useful to clear larger than stock suspension, increase track width for potentially improved lateral stability(though I dont know how much it really does), and some people just thinks it looks cooler. There is some debate it puts more stress on your bearings, but there are plenty of people who will tell you they have been running them a long time with no issues, and plenty of people who will say the spacers are why their front wheel bearing went out 5000 miles later. I will be using them to clear larger shocks in the rear. Wheel bearings are easy, so I am not concerned about it. Run some on my FJ Cruiser and to me they are no big deal. It is recommended to buy from a reputable brand like Bora or spidertrax. Up to 1.5 isnt bad but 2+ can be a little sketchy imo.

 

For me it was clearing bigger tires since the OEM wheels have terrible offset for anything but stock. Even with my 1.5" spacers I'm an inch away from the coils with 255/75r17s...

 

Great information Thank you

 

What's shipping to 93561 for the set of Lower Control Arms??

 

I’ll take the BAMF kit next time I’m in Denton. What part of DFW?

 

Where in TX are you? Interested in drive shaft.

 

He's up near me. If you work it out with him, I'm meeting with him today. I'll pick up the shaft and drop it off when I come down there.

 

Same as above. Waco will be on my way down.

 

Sent him a message but haven’t heard back yet, if you were able to bring them down that’d be awesome but I can also wait until next time I head up

 

I’m in Dallas. I can give it to @Naveronski today if you would like.

 

Want me to hold it until your up here next or pass it off to @Naveronski today?

 

@Naveronski When will you be near waco? If it's soon I'll probably just hand it off to him

 

Most likely the 13th.

 

Thanks fellas, I appreciate y'all.