What Have You Done To Your 2nd Gen Tacoma Today?

Taco and I worked hard today. Lots of idiots on road today which Taco deftly avoided. I think I will treat Taco to a tank of premium next fill up.

 

Hauled some topsoil for the flower beds

 

Map lights on with dome light.

 

Picked up a new toy today

 

Looks good!

 

What are your rear lights....thanks

 

Put on retro bed decals.

 

Haha

 

I do not. Sorry.
I don't take good notes for others when I hack things together... my colleagues complain about it all the time.

I can try to explain it tho.

The rear part is this: https://www.amazon.com/Upgraded-Ver...nhan+quick+charge+usb+3&qid=1619148309&sr=8-4
There are others just like it that do not have the voltage display and the on/off button.
I wanted a separate voltage display because I have a secondary battery and I ran the rear adapter to that battery and not the main truck battery.

The rear center console one was pretty easy.
There isn't a lot of room back there to install it though, it can't go many places, find what works. I used the upper right corner (looking from the rear seats).
I took the rear center console out, you only have to open the center storage and take all your junk out, then lift the little carpet piece at the bottom.
IIRC, it's 2 screws and that back piece will come out.
I then got a step drill bit and drilled out a hole up to almost the size of the USB adapter.
I then enlarged the hole slightly by carefully running a small round file, by hand, around the hole until I could just fit the adapter in.

As far as wiring it, I had it easy, I have a secondary battery system, ham radios, dashboard linux computer, and other associated wires from that running all over the place, so I just tapped into one of those.
If you need to though, you could run some wires forward through the "between the seats" center console (which you will see is not hard to remove at this point).
There is a decent tap into a "mostly hot" 12 volt wire behind the radio (and probably several other places, I tend to create new circuits for each new accessory though).

I hope that helps! (even a little)
You can DM me any more questions you have if you like.

73

 

cleaned the engine and did the unifilter mod

 

jumped on the sale from AFE and got an aluminum radiator for 22% off of their msrp.

 

Which ones did you go with?

 

What is the unifilter mod
Thanks

 

Take a look at the video @boogie3478 put together:

https://youtu.be/XO5d4MqZu5I

 

The small red paper filter you see on the left side of his picture. It replaces a cap that's normally there and allows you to remove the internal foam filter that purportedly can disintegrated and get ingested into the engine, leading to a very bad time.

Essential? Probably not. But also inexpensive and gives some peace of mind.

 

Thanks, looked it up, starts with late 2011s and 2012s
I’ve got. A 2010, so nothing there.

 

This is the part. Someone must have hijacked their site and now it's fixed.

https://ultra-gauge.com/ZC/index.ph..._id=18&zenid=463204946f2d44049d3570b6157c23ba

 

The part with the adhesive is flexible, I'm thinking to conform to curves in a dashboard should you mount it there. It fits tight to the glass, just clean the glass before sticking it on.

 

Thanks , not that I know of.

About 10 min. each side. Didn't even take the wheels off.

 

Does anyone know ultragauge is still in business?

Still highjacked.....I was wondering if they were still in business since it brings me to a Viagra website and everywhere on the internet including Amazon says that Ultragauges are currently unavailable.