What Have You Done To Your 2nd Gen Tacoma Today?

255/80s you may be able to avoid the chop with an alignment... I did not need a chop for that size, just bumped my caster up.

 

Though I had a 2.5" lift and after market ucas at the time. Not sure what you are running. Looks good though!

 

I don't want to use that public area

 

I can smell it from Tennessee..

 

Homemade ax/shovel mount. 1/4x2 FB, some holes, bolts, hose and quickfists.

 

Simple and effective, like it!

 

Thanks man! I was going to do some fancy cutting/bending and just thought, what am I doing. Keep it simple, stupid.

Anyone looking to do something similar in future, I would recommend adding something for dampening down at the bottom. I used some old hose, didn’t want anything rubbing the bed.

 

I was wondering what the hose was for in your description lol

 

Well I am also a part-time hoser, eh.

 

Finished the harness for my Kicker Key 180.4 and 500.1. Just need a dry day to drop it in.


After a second thought I added a little toe guard to the amp rack to keep kiddos from kicking the wiring. Also drilled spots for securing the wiring down with zip ties once I get the harness snaked through the dash and center console.

 

Cleaned my engine bay. Which was really the result of installing my Redline hood struts. It just looked shitty, so I cleaned it.

Simple Green and just manual labor. Brushes, cloths, and covering electrical things (fuse box and alternator). Battery was removed. And I'm glad I did since it was kinda dirty below that.

Before


After

 

Install almost complete. Can’t wait to see the finished product

 

Got new Icon wheels. 17in Rebounds in titanium grey. Decided to sell my dogecoin profits and order a ton of stuff so I’m stoked for more stuff to come in!

 

Is this going under the passenger seat?

 

Its possible it could have some clarity effects. I cant say for certain as when i did mine, it went from the Mirror to being shown on both the mirror and the Kenwood. I just figure, its only a few dollars for a decent cable and it may prevent it from getting crimped as well. When i ordeded my amp kit from KnuKonceptz, i just ordered an extra 6ft RCA with it and used one side of it.

 

Did the cmc for 285/75/17 and I still rub. I have spc uca set to D setting and LCA maxed out caster. S.O.S Will setting the UCA to the E setting help at all?

also don’t pay any attention to the horrific welding I did...

 

That's what grinders are for )

 

Driver. Seat spacers look like they’ll give me plenty of clearance, and the amp board only lifts the amps enough to clear the floor vent.

 

I was finally due for new tires so I made the jump from Hankook 265/75/16 to Toyo AT3 255/80/17. Only rubbing was front mud flaps at reverse so those are gone. So far liking the new setup and really digging these 4runner wheels. Like how they look and stick out enough to line up with the fender compared to the tucked in OR wheels I previously had. Now my tires fill in the wheel well more and don't look too small for my lift lol

 

Taking the mower to the shop for some warranty work.