Back sliding window not working

Hi, anybody

Can anybody know where 2018 tacoma back sliding window fuse located?
If know provide some advice.
Thank !

 

In the cab, large pink LP JCase 30 amp fuse.

 

You'll need one of these:

$12 Littelfuse 00970053XP for JCase Fuses

https://www.amazon.com/Littelfuse-00970053XP-for-JCase-Fuses/dp/B076PQMKRG

 

If Driver's side also is non-functional then fuse #1 is shared for the sliding rear window switch, #2 is for the sliding rear window motor. Verify the cause before the replacement fuse fails also.

 

It's working now.
Thank you so much

 

Did you notice the fuse puller on the fuse map ??

 

Have YOU used to remove a LP JCASE fuse?

 

I’d give it a shot, might have to work one side at a time. Likely doable.

 

SO that's a NO///

 

Haha. I always at least try with the tools I have on hand, if the fuse puller doesn’t work I have a variety of trim removal tools on hand to try next. Special tools are worth it if you use them often otherwise naaah.

 

I see, $6.00 for a proper tool is way to much. There are at least 13 LP JCase fuses in the 3rd Gen Taco. But you go pry away...

 

Will do it’s just not that hard, been doing electrical work most of my life lol. And if you keep blowing fuses you have more problems than just a fuse

 

Reviving this thread since it’s all I Can find on the rear slider not working. I Went to use the slider today, I hadn’t used it for about a month. It’s not working now. Here is what I have tested:
- checked fuse. Not blown and has continuity.
- tested switch. I’m not familiar with the pin payout but the pins seem to all function properly. Meaning there is ground and power, also when you rock the switch it applies a power output. the switch also illuminates when dash lights are on. I’m thinking the switch it fine.

I think the relay may be bad but I’m not sure where it is located. I searched the net for a bit with no success. The reason. Think it’s bad is because when I use the rocker switch I don’t hear a relay click anywhere in the truck. I recall that there was a relay clicking noise before, when using the switch. Can anyone confirm this? I’m hoping it’s just that and not the motor. Any help with this would be greatly appreciated. Thank you in advance.

 

I also just noticed that my usb and lightning charge ports in center arm rest are no longer working. So checked the usb fuse in cab and it’s fine. Any help would be great.

 

I have the same issue.
Window fuses are good, but no windows move, including the rear, amd no power in arm rest usb