New design eBay snorkel

That is true! About dust. Perhaps I should consider

 

If you end up taking off the inner fender liners it’s probably best to reroute your air intake.

 

They do look pretty awesome though.

 

I knew I was getting a lot of water and mud in my intake tube but didn't know just how much until I pulled out my fender liner and removed the factory tube. This is not from water crossings but from quick runs through deep mud holes. I also like the fact that I'm not sucking in all the trail dust from the guy in front of me. On the road my intake air temps dropped dramatically. Cold air is better than hot.

 

Holes in my intake setup + 35's with no fender liners + siliconed drain holes + 2 hours of monsoon rain =

https://www.youtube.com/watch?v=i4-BvzenlCk

I should probs get the dorkel on soon.

 

Danng!! That's a lot of nasty looking h2o.

 

This has been annoying.






waiting on an m4 mandrel now for the a pillar.

 

Would removing the ditch light bracket make it easier? You don’t need to remove your fenders to install.

Im using Rago Fab ditch light brackets and they don’t get in the way. They were installed in after the snorkel. I also want to say they make a CB antenna attachment for the brackets as well.

 

I’m running both a ditch light and cb antennas on my brackets. Rago’s move with the hood, I don’t like that. I needed to remove the fenders for other reasons. Nothing about my setup is common, so as expected nothing is easy.

This is the custom setup I originally made that needed to be modified for the snorkel.

 

Rivnuts and dorkel done.

Untitled by Michael Halat, on Flickr
Untitled by Michael Halat, on Flickr
Untitled by Michael Halat, on Flickr

 

It’s not much, but it’s an honest living. WTX farmlands have an abundance of rain and multitudes of paved water crossings. This one was about 1.5’ and static with a road hazard. I was hoping to get a little hydroplane action but the pizza cutters did their job. Eventually found my rig.

 

Bet you throw it in the ocean it would be found on a deserted island in Indo just like all the other plastic does.

 

I see everyone else's template is paper with directions on it. Mine just came with a slightly mangled cardboard template.

 

LOL

 

FYI guys, some people were asking me so I made another batch!

I have all 3 designs back in stock for the snorkel badge.

Gray TRD
Red TRD
Stripes TRD



its $15 shipped in the US for the badge, they are 3D domed with clear resin so its an actual badge.


<-Start a conversation with me if you need one!


Kens04Taco - Got my gel sticker from @CBoy808. Looks great thanks again bud!




Photo from SafetyDang


Photo from chrslefty

 

Which eBay seller is everyone getting the snorkel from? I see multiple sellers on eBay, but after reviewing the pictures they post, I do not see the one with the brass nuts.

 

This is the one I got.

https://www.ebay.com/itm/Vehicle-Sn...RUNNER-1995-2004-1st-Gen-Tacoma-/283206681326

 

Awesome! Thank you sir.

 

I got the same one. Delivered it fast. Happy with mine.

 

No problemo. I got a rivnut gun from harbor freight that was surprisingly really good quality, along with some silicone, makes it so I can take the mount on and off with ease like previously done on this thread, instead of using self tappers.