What Have You Done To Your 2nd Gen Tacoma Today?

Installed a fancy trailgate. Now hopefully I won't spill my Kool-Aid anymore.

 

2 coats of Mothers Synthetic Wax on roof and hood, 1 coat everywhere else.

 

‘tis just a baby!

 

Did you reuse the shim?

 

Oil change, rotate/balance, engine air filter, cabin air filter, wiper blade inserts.
Swept out the debris that was in the bed and enlarged the two front outer drain holes in the bed to 1/2".

Truck is very close to turning 150,000

While under the truck I noticed that the R/F axle boot has a tear in it letting out grease (need new boots). I should've done the diff drop sooner.
I also saw that my L/R axle seal is leaking. I can't get the drum off so it looks like I'm going to need drums and shoes on the rear along with a new seal. Should I do the passenger side seal as well?

 

Shows you how much I know lol

 

Changed plugs, air filter, cabin air filter, tranny fluid, and engine oil. I also cleaned out the interior and the bed because I'm dropping it off for a new frame tomorrow.

 

That is a great idea! I appreciate the suggestion. I might give this a shot here soon. What did you use for your "deadener"? Any chance you have some pics before putting the door panel back on?

 

There were 4 shims in the stock one. We reused 1 or 2, and 1 or 2 from the new pack.

Got it perfect.

 

Front frame end caps installed, looks way better!

 

Installed a Toyota OEM roof rack on my Adventure Taco today. Ordered from OEM Part Source in Ohio. Reasonably easy, had to work a couple bolts, but not much trouble. For hauling my canoe, kayak, and surfboard. Tomorrow’s project: wash.

 

When I do them I use what ever came out of the old one (never used a feeler gauge to check). I made the mistake once of forgetting to reuse a shim and I had to take it back apart.

 

You should do both with 150,000 miles if one is already leaking.....it is only a quick matter of time before the other one goes. How is the snorkel situation?

 

Greetings..

 

You don't know until you ask. Learn something new on this site all the time.

 

Shop I used to go to took the lifts out - there was too much red tape and expense involved with maintaining the lift, employee training etc. They found it cheaper to use jacks.

 

No more frame rub. I installed Bora 0.75” spacers. They give me an effective backspace of 3.5”.

 

New sticker lol!

 

Your only going to lose half the difference in wheel height in clearance, the other half goes to raising the whole truck.

 

what were your symptoms before?