What Have You Done To Your 3rd Gen Today?

"malt liquor" .. LOL

 

“Sippy cup…”

 

I had a CMC + pinch weld flattened down. I trimmed some of the inner fender near the cab side. Also used a heat gun to mold the fender lining back a little. The offset of your wheels will play a huge factor in how much you rub, the more negative offset you run, plan on trimming more. If you plan on wheeling the truck a lot I say its worth it. I still rub on the cab mount but very minimal at full lock. These tires are measured at 33.9". I was going to run 35's but was not wanting to trim my fenders. I figured the clearance you get was marginal at best factoring in the weight on the tires + worse gas mileage + wear on drive shafts/transmission. I am also on factory gears and would like to eventually get 5.29's

 

Just took delivery of these bad boys. Getting them mounted on Monday.

 

It's happening!

 

Line-X!!!!

 

Good luck getting very far on corrugated paper boxes, hope it doesn't rain any time soon!

 

I went from stock to BFG 285/70/17 KO2's on stock sport suspension and only had to trim a single tab off of the front bumper. I dont think an extra 5CM would make much of a difference with regards to what needs to be trimmed. MAYBE a small bit of the fender flair on the back side of the wheel well where it pulls into/under the liner. If you have any sort of a lift at all you should be fine with just the front trim that I did. Plus, BFG runs large. my 285/70/17 are 32.8" in diameter

Here is my previous post for reference:

 

This is going to look badass!

 

Dakars? Jelly

 

So you have no rub on the fenders or UCAs? How much offset do you have on your tires?

 

The blue and bronze looks really good together.

 

Tailgate spoiler? How about a cab spoiler, that's the real gangster move!



Not your speed, boss? Ok how about one of these bad bitches?



If not, I've also got two 2021 Taco air dams (free to anyone looking... does anyone ever look for that??) which could be franken-spoilered into some hot mess of downforce.

 

The BAK Revolver is nice too (See my post here)

 

New tires and alignment today.

 

Good info, Thanks for your time!

 

Clay bar, followed with a coat of Turtle Wax Graphene, 303 Protectant on all interior trim, leather and exterior plastics. Also added a TRD badge to the grill. Third vehicle I’ve used the TW Graphene on and I really like it. Easy to use, readily available, and holding up well.

 

Strykers actually. I like all three of their models but really dig the 5 spoke look.

 

Calvary Blue and Bronze is straight up sexy as hell! Nice job!