Cool K9 Wiring help.

If I could please get some help from one of you experts.

I have a 2019 Tacoma that I am looking for the wire that makes the rear sliding window open.
We have a police K9 and I am installing the Viper Tactical Cool K9 in the truck. The way the Cool K9 works. It has 2 temp probs and a control head. I cant set a temp on it and if the temp in the truck gets to hot. It will flash my strobes, honk the horn, roll down two windows and turn on a fan.

But what I would like it to do is open the rear slinging window cause I have the OG Fab rear glass vent/security panel and I am going to attach the fan to it. I don't want to roll down the rear door windows cause I don't have anything covering them.

(Stock photo not my truck)


Here is the diagram for the Cool K9



Thanks for everyone's help!

 

I guess you could unplug the rear window motors?

 

Sweet thanks!!

I will post when it's done this weekend

 

In for pics of K9 truck

 

No I don't want to do that. Then I can't open or close it.

I am thinking caribe makaira posted will be right. If I apply 12v to the Pink #4 wire the window should open.

 

Nope...It's a ground actuated circuit. Read the small letters on the instructions you posted.

 

Ok, So I will need the relay. Easy any Autozone will have one.

 

Nope...



No relay

 

Here are a few photos of Ella. We are hoping she will be done with training in about a month. So that's why I need to get this truck done.

Thanks everyone for your help!

 

Humm, I don't understand. If I cant tap in to the pink wire with blue primary and don't need the relay. How should it be wired?

 

The module does the function of the sliding window switch i.e. provides a ground.

 

ok. So where is this at? behind the plastic under the rear window?

 

At the dash sliding window switch. Connector behind the switch.

 

of course it would be lol. The hardest switch to get too.

 

What? if it's on the middle dash I'd say yes. But if it's on the Cubby, no way hard at all.

 

I have the complete Off Grid dual battery setup already installed and going to take the power from the 2nd battery to power the fan.

 

In the middle and a lot of stuff I have to remove to get to it. But oh well. It's going to be sweet when done. I did not go with the door pop cause I was not sure about it. After all you smart guys helping me. I wish I got it. Maybe a mod for another day.

 

Careful use of a panel tool to remove the switch, but routing the wire to it is a chore.

 

Yeah and I want to install the control unit up where my crawl control is located